ServicesGutter Repair
Gutter Repair in Sangaree
A dripping corner or a sagging run usually traces back to one small failure: a backed-out spike, a dried joint, a pitch that drifted. We find that cause, fix it properly and show you what we did, so your gutters carry water away from your home again.

Repair the Cause, Not Just the Drip
Most gutter problems start small. A sealant bead at a miter corner shrinks and cracks after a few years of sun. A spike-and-ferrule hanger loosens as the fascia board swells and dries, and the run tips forward. Water then sits where it should flow, and the extra weight pulls more fasteners loose.
Our repairs go after that chain of events. We pull the old caulk out of a joint before resealing it, replace loose spikes with hidden hangers screwed into solid wood, and re-set the slope so water reaches the outlet. Those details take a little longer on the day, and they are what decide whether the fix lasts.
If a section is too far gone to repair honestly, we will tell you and explain the option of gutter installation for that run. Most of the time, a targeted repair is the right answer.
What a Gutter Repair Includes
Joint and corner resealing
We scrape out failed sealant, clean the metal down to bare aluminum and apply a gutter-grade sealant that stays flexible. Laying new caulk over old caulk is why many patched corners leak again within a season.
Rehanging sagging runs
Loose spikes get replaced with hidden hangers fastened by screws into the fascia or rafter tails. Screws hold where smooth spikes slowly back out, and we space hangers closer on long or heavily loaded runs.
Pitch correction
A gutter needs a steady fall toward its outlet, roughly a quarter inch every ten feet. We check it with a level and adjust hangers so water stops pooling in the middle of the run.
End caps and outlets
Leaking end caps are removed, cleaned and reset. We reseal outlet connections where water escapes at the drop instead of draining through it.
Fascia check behind the gutter
With the gutter loosened, we look at the board it hangs on. Soft or rotted wood will not hold a fastener, so we show you photos and talk through it before anything goes back up.

Signs Your Gutters Need Repair
- Drips at corners and joints
- Water running down the face of the gutter at a miter or slip joint means the seal has failed. It often leaves dark streaks on siding or brick below.
- A run pulling away from the fascia
- A visible gap between gutter and board, or a spike head sticking out, points to fasteners losing their grip.
- Standing water after rain
- If water sits in the trough a day after a storm, the pitch is off or a hanger has dropped. Standing water adds weight and speeds corrosion.
- Overflow in heavy storms
- Summer thunderstorms here dump a lot of water fast. A gutter that spills over its front edge when it is not clogged may be tilted forward or sagging between hangers.
- Peeling paint or soft trim
- Rot or blistering paint on fascia and soffit behind the gutter often means water has been getting behind the back edge for a while.
- Erosion along the foundation
- Washed-out mulch or a trench in the soil under one spot tells you exactly where the gutter is dumping water.
How a Repair Visit Runs
- 1
Inspection and photos
We walk the full gutter line, check the joints, hangers and slope, and photograph what we find. You see the problem spots, not just our word for it.
- 2
A clear written estimate
You get a line-item estimate for each repair, with a straight answer on whether repair or replacement makes sense for each run.
- 3
The repair work
We set ladders with standoffs so they do not crush the gutter, protect plantings below, then reseal, rehang and re-pitch as quoted.
- 4
Water test and cleanup
We run water through the repaired sections to confirm the joints hold and the flow reaches the outlet. Old fasteners, caulk and scraps leave with us.
What Affects the Cost of Gutter Repair
The price of a repair is set by what we find up close, not by the length of your gutter line. Resealing one leaking corner is a short job, while a long run with several dropped hangers and a soft fascia board takes more time and material. Your free estimate lists each repair on its own line, so you can see what you are paying for before any work begins.
- Number of failure points
- Every leaking joint, loose end cap or sagging section counts as a separate task. Handling several of them in one visit costs less than calling us back for each one.
- Roof height and access
- Two-story eaves, sloped beds below the gutter or a run above a sunroom mean more ladder setup and sometimes extra equipment compared with a single-story ranch.
- Fascia condition
- A hanger is only as strong as the wood its screw bites into. When the board has gone soft, that wood needs attention first so the new fasteners have something solid to grip, which adds lumber and labor to the job.
- Gutter material
- Aluminum is the most common and the most straightforward to repair. Copper and older steel gutters need parts and fasteners of a compatible metal so the two do not corrode each other, and those parts cost more.
Gutter Repair Questions
- Can you just reseal my leaking gutter corners?
- Yes, and it is one of the most common repairs we do. The key is removing the old sealant and cleaning the metal first, because new caulk does not bond well to dried caulk or oxidized aluminum. Done that way, a resealed corner holds far longer than a quick patch.
- Is it worth repairing, or should I replace the gutters?
- If the metal is sound and the problems are joints, hangers or pitch, repair is usually the better value. Replacement makes sense when the trough is badly dented, corroded through or undersized for the roof. We show you photos and give an honest answer either way.
- Do your repairs come with a warranty?
- Yes. Our gutter repair work is covered by a 2-year workmanship warranty. If a joint or hanger we worked on fails because of how we did it, we come back and make it right.
- Why do my gutters keep pulling away from the house?
- Usually the original spike-and-ferrule fasteners have worked loose as the wood moved with heat and humidity, or the fascia behind them has softened. We replace them with screw-fastened hidden hangers and check the board before rehanging.
- Has your company earned any outside recognition?
- Yes. Our work earned an Angie's List Super Service Award in 2018. We handle gutter repair across Sangaree and in nearby towns such as Ladson, Summerville and Goose Creek.
Find Out What Is Behind the Leak
We will inspect your gutters, photograph the problem spots and explain what each repair involves. Gutter guards or gutter covers can be added at the same time if debris is part of the story.